1) Dip Switch configuration changed as follows:
DIP SW #1 = COR #1 Polarity
DIP SW #2 = CTCSS #1 Polarity
DIP SW #3 = COR #2 Polarity
DIP SW #4 = CTCSS #2 Polarity

2) CTCSS override channel (#4) was not working when COR proceeded CTCSS to override DTMF access.

3) With repeater at rest, first keyup was not triggering the Long ID.

1) Link input was not responding whenever the PL override channel was active.

2) Chip Select to the voice chip lengthen in time. Config 0 byte.

3) Courtesy beep was not changing between main port and link port.

1) Support for the Doug Hall RBI-1 Kenwood Radio interface unit added.

2) Zone 2 channel 3 activated. Regenerates DTMF out port #2 instead of port #1.

3) DVR track serial transmission corrected to match the CAT-1000 and CAT-300. This change was necessary for the new DR1000.

4) Added PTT and a voice delay when calling voice mess and DVR tracks directly from the scheduler.

5) Corrected the CW buffer, if empty, causing the transmitter to remain on if a CW message is called.

1) Fixed courtesy tone erase via DTMF.

2) Fixed entry problem with entering a zero inter-digit courtesy tone delay.

3) Fixed problem with final ID in CW whenever both ID voice messages OFF.

1) ICOM HF support added.

2) Fixed macro calls whenever Zone 1 Channel 1 is OFF.

1) Added "100 Hz" to the HF frequency read back.

2) Added to the HF loop a drop of PTT#2 whenever DTMF from Port #1 is detected.

3) After a CRT upload, zone channels within processor were not being updated.