1) Voice variables for controlling the link (120, 121, 122) have been added.

2) Zone 4, Channel 5 added (Voice ID enable)

3) CW tone frequency moved from 1000 Hz to 900 Hz.

4) Voice messages increased from 8 messages to 12 messages.

5) New voice message 8 "Link On" added to the link connect command.

6) New voice message 9 "Link Off" added to the link disconnect command.

7) New voice message 10 "Link Time Out" added to the auto link disconnect.

8) Enter from the CRT routine now available with *97 command.

9) Fan turn-off fixed.

10) DTMF muting from port #2 was not working and has been corrected.

11) Correct main PTT (port#1) from not dropping whenever the link is activated from port #2.

1) Fixed no courtesy beep with COR #2 active while the link is OFF.

2) Fix hardware inputs not being disabled via zone channel during hardware timer voc calls.

3) Fix the problem with PTT #1 dropping after COR drop if the link was activated.

4) Force "D" key feature added.

5) User function triggering messages were not keying the link if Zone 2 Channel 5 was turned on.

6) User function output 2,3, and 4 (On only) were not working within a voice message.

1) Zone 4, Channel 8 CTCSS Encoder Switch Enable added.

2) Added user output 5 and 6 control from within a voice message.

1) Voice word "connect" said upon entry into data upload.

2) ID enable channel, when off, was causing a momentary PTT.

1) Enable entry into PRGM mode when Zone 1 Channel 1 is Off.

1) If the fan control is active, force the fan output off (UF #6) when zone 4 channel 4 is turned off.

1) When link was enabled from port #2 with link auto disconnect channel on, link would drop immediately.

1) Fix CTCSS encoder switching during a CW ID.