CAT Note 12

	Computer Automation Technology Fort Lauderdale, Florida	CAT Note 12
	Release Date: March 11, 2004
	Connecting a CAT to a Kenwood TKR-750

Connecting a CAT controller to a Kenwood TKR-750 Repeater can be accomplished easily by following these two steps.

Step 1
Build an interconnect cable with two Male DB25 connectors on both ends of a 5-wire conductor cable. Connect the pins as follows: (Note: a pre-built cable is available for purchase under CAT part number CA-750).

FUNCTION	CAT controller	TKR-750	NOTES
Signal and Logic Grounds	Pin 17	Pin 19
Receiver COR #1	Pin 6	Pin 24	Signal goes high with a COR
Receiver Audio	Pin 13	Pin 11	RX audio to CAT controller
Transmitter Audio	Pin 11	Pin 9	TX audio from CAT controller
PTT #1	Pin 10	Pin 16	TKR-750 Transmitter Control

Step 2
Program the TKR-750 repeater using the configuration software supplied with the repeater.

PARAMETER	CONFIGURED AS
Frequency	Required RX and TX frequency pair
QT/DQT Dec.	None
QT/DQT Enc.	None
W/N	Narrow
Repeat	No
Scan Del/Add	Del
CW ID	No
AUX In/Out 5	COR with Logic Type set for Active High

Notes:
None

This site is best viewed with Internet Explore 5.0 and above or Netscape 6.0 and above.

Computer Automation Technology, Inc.
4631 N.W. 31st Avenue, Suite 142
Fort Lauderdale, Florida 33309

Send mail to Webmaster with questions or comments about this web site.