Have anyone done is any really good Sounding Courtesy Tones for the Repeater with the CAT-1000 Controller?? And if so can I get the Seperations,the...
Hello Everyone... Well here we go with another project. As most of you know you can get a PL logic signal from the VXR7000 using the 8pin RJ45 using...
We are currently using a CAT 1000 and a Peet Ultimeter to output voice weather data on our repeater. This has been working very nicely for over 2...
Tried to turn on the PL last night (1-2) but repeater went deaf. Been looking to find PL setting and/or read back info in the manual. Almost afraid...
Hello All, Putting a battery power announcement on club's CAT1000. Would like to use the control delay to keep controller from switching when...
Has anyone looked into the potential of having the 1000 controller automatically announce when the repeater is on battery backup? I suspect that...
I have a Cat 1000 with firmware 4.00B connected to a Doug Hall interface using a Kenwood TM-701 radio for remote base operation. I know there is a...
Is there any way to adjust the interdigit spacing/tone length on the DTMF generator? I've looked and can't find it, but I could have missed it. ...
We have installed a CAT1000 and WX200 on a new Kenwood TKR750 repeater. It has taken a long time to get to the point were everything works but it...
I am wondering if anyone has worked with adding an audio delay on the CAT 1000? I went up today to add a delay board and noticed that the CAT 1000...
There are currently 1 users browsing this forum. (0 members and 1 guests and [ARG:3 UNDEFINED] spiders)
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
