AP-100 Audio Processor

AP-100 Audio Processor Board

Place the AP-100 in the receiver’s audio path to compensate your communication system’s frequency response. The LOW and HIGH frequency controls can be adjusted independently with each having a range greater than 20dB. An overall gain control is also provided. It becomes a simple matter to compare the signal on the input of your repeater to the signal heard on the repeater’s output and adjust the frequency response accordingly. The AP-100 becomes invaluable when setting up a voting system and making the audio response identical from each remote site. As the voter panel switches receivers, a person listing to the repeater output will not be able to detect any change in the audio.

SQ-1000

Board size is 2.0 X 2.5 inches.

This is a plug and play accessory. No soldering required.

Installation is easy. Remove the jumper plug from the Controller’s Delay Line header and connect the AP-100 cable. Make sure the jumpers on the AP-100 board are on positions 1 and 2 and connect the AP-100 and controller as shown in Figure 1 below with the included cable jumper.

To use the AP-100 in conjunction with an Audio Delay board, move the jumpers to positions 3 and 4 and connect the controller, AP-100 and Audio Delay board as shown in Figure 2.

Ordering Information
AP-100	Audio Processor Board $59.00
Order Online

This site is best viewed with minimum Internet Explore 5.0, Netscape 6.0, and Firefox 2.0.

Computer Automation Technology, Inc.
4631 N.W. 31st Avenue, Suite 142
Fort Lauderdale, Florida 33309

Send mail to Webmaster with questions or comments about this web site.